ABSTRACT
OBJECTIVE@#To investigate the gene mutation occurved in AML patients with 29 kinds of fusion genes and 51 kinds of tumor gene.@*METHODS@#Next-generation sequencing (NGS) was used to detected the 49 kinds of targeted gene. FLT3 internal tandem duplication (FLT3-ITD), CALR, NPM1 and CEBPA mutation were detected by DNA-based PCR and Sanger sequencing. Twenty-nine kinds of fusion genes were dected by multiplex nested RT-PCR.@*RESULTS@#The total gene mutation rate was 91% (109/121) in all the 121 patients. On average, 2.1 mutated genes per patient were identified, among these 121 patients, coexistence of ≥ 3 mutations was frequent (34.7%). The most commonly mutated genes were NRAS (23.96%, n=29), followed by NPM1 (14.04%, n=17), CEBPA double mutations (14.04%, n=17), KRAS (11.57%, n=14)，FLT3-ITD (10.74%, n=13), CSF3R (10.74%, n=13), TET2 (9.92%, n=12) and IDH1 (9.1%, n=11). Overall, fusion genes were detected in 47 (37.3%) patients, including AML/ETO (n=12), CBFβ/MYH11 (n=11), PML/RARa (n=12), MLL rearranagement realated mutation MLL-X (n=10). TLS/ERG (n=1) and DEK/CAN (n=1) in an order of decreasing frequency. Patients with normal karyotype (NK)- AML exhibited more mutations in CEBPA, NPM1, TET2, RUNX1 and IDH1, comparing with abnormal karyotype patients. KRAS mutation in abnormal kayotype patients was significantly higher than that in normal kayotype patients (P=0.014). TP53 mutations were predominantly associated with complex cytogenetics (P=0.199). KRAS mutations were more frequent in core binding factor (CBF) acute myeloid leukemia (AML) and 11q23/MLL rearrangement leukemia, compared with NK-AML (P=0.006 and 0.003, respectively). KIT mutations predominated in CBF-AML (P=0.006). JAK2V617F mutations were detected in two patients and co-occurred with AML-ETO fusions.@*CONCLUSION@#At least one mutation is observed in more than 90% patients. On average, more than 2 mutated genes per patient are identified. Some gene mutations are associated with gene rearrangement.
Subject(s)
Humans , Chromosomal Proteins, Non-Histone , Genomics , High-Throughput Nucleotide Sequencing , Leukemia, Myeloid, Acute , Mutation , Oncogene Proteins , Poly-ADP-Ribose Binding Proteins , PrognosisABSTRACT
Phytantriol (PT), ethanol (ET) and water were used to prepare in situ cubic liquid crystal (ISV2). The pseudo-ternary phase diagram of PT-ET-water was constructed and isotropic solution formulations were chosen for further optimization. The physicochemical properties of isotropic solution formulations were evaluated to optimize the composition of ISV2. In situ hexagonal liquid crystals (ISH2) were prepared based on the composition of ISV2 with the addition of vitamin E acetate (VitEA) and the amount of VitEA was optimized by in vitro release behavior. The phase structures of liquid crystalline gels formed by ISV2 and ISH2 in excess water were confirmed by crossed polarized light microscopy and small angle X-ray scattering, respectively. Rheological properties of ISV2 and ISH2 were studied by a DHR-2 rheometer. In vitro drug release studies were conducted by using a dialysis membrane diffusion method. Pharmacokinetics was investigated by determination of sinomenine hydrochloride (SMH) concentration in synovial membrane after intra-articular injection of SMH-loaded ISH2 in adjuvant-induced arthritis rats. The optimal ISV2 (PT/ET/water, 64:16:20, w/w/w) loaded with 6 mg·g-1 of SMH showed a suitable pH, injectable and formed a cubic liquid crystalline gel in situ with minimum water absorption in the shortest time. The optimal ISV2 was able to sustain the drug release for 144 h. The optimal ISH2 system was prepared by addition of 5% VitEA into PT in the optimal ISV2 system. This ISH2 (PT/VitEA/ET/water, 60.8:3.2:16:20, w/w/w/w) was an injectable isotropic solution with suitable pH. The new ISH2 was able to sustain the drug release for more than 240 h. Local pharmacokinetics study indicated that the retention time and AUC0-∞ of ISH2 group were increased significantly compared with that of SMH solution group and the AUC0-∞ of ISH2 group was 6.01 times higher than that of SMH solution group. The developed ISH2 was suitable for intra-articular injection that may apply to patients in the treatment of rheumatoid arthritis.
ABSTRACT
Phytantriol (PT), ethanol (ET) and water were used to prepare in situ cubic liquid crystal (ISV2). The pseudo-ternary phase diagram of PT-ET-water was constructed and isotropic solution formulations were chosen for further optimization. The physicochemical properties of isotropic solution formulations were evaluated to optimize the composition of ISV2. In situ hexagonal liquid crystals (ISH2) were prepared based on the composition of ISV2 with the addition of vitamin E acetate (VitEA) and the amount of VitEA was optimized by in vitro release behavior. The phase structures of liquid crystalline gels formed by ISV2 and ISH2 in excess water were confirmed by crossed polarized light microscopy and small angle X-ray scattering, respectively. Rheological properties of ISV2 and ISH2 were studied by a DHR-2 rheometer. In vitro drug release studies were conducted by using a dialysis membrane diffusion method. Pharmacokinetics was investigated by determination of sinomenine hydrochloride (SMH) concentration in synovial membrane after intra-articular injection of SMH-loaded ISH2 in adjuvant-induced arthritis rats. The optimal ISV2 (PT/ET/water, 64 : 16 : 20, w/w/w) loaded with 6 mg x g(-1) of SMH showed a suitable pH, injectable and formed a cubic liquid crystalline gel in situ with minimum water absorption in the shortest time. The optimal ISV2 was able to sustain the drug release for 144 h. The optimal ISH2 system was prepared by addition of 5% VitEA into PT in the optimal ISV2 system. This ISH2 (PT/VitEA/ET/water, 60.8 : 3.2 : 16 : 20, w/w/w/w) was an injectable isotropic solution with suitable pH. The new ISH2 was able to sustain the drug release for more than 240 h. Local pharmacokinetics study indicated that the retention time and AUC(0-∞) of ISH2 group were increased significantly compared with that of SMH solution group and the AUC(0-∞) of ISH2 group was 6.01 times higher than that of SMH solution group. The developed ISH2 was suitable for intra-articular injection that may apply to patients in the treatment of rheumatoid arthritis.